WAVE OVERTOPPING WITH A CHANGING STEEP SANDY FORESHORE, CONVENTIONAL AND NUMERICAL ANALYSIS OF RESULTS

Jentsje van der Meer, Rizki Akbar, Ryard Mukhdiar, Riccardo Briganti, Rosaria Ester Musumeci, Alessandro Romano, Tomohiro Suzuki, Corrado Altomare

Abstract


Large scale tests were performed in the large scale facility GWK at Hannover, Germany, within the HYDRALAB+ project ICODEP: Impact of Changing fOreshore on flood DEfence Performance. The test set-up consisted of a relatively steep 1:15 sandy beach profile in front of a battered seawall with 10:1 slope (almost vertical). Two storms were generated, S1 and S2 with for each storm a specific combined surge and tide profile with varying wave conditions (sea states) depending on water level. These two types of storms have been modelled in varying order, giving three types of storm clusters (C1, C2, and C3). After each sea state the foreshore profile was measured and during each sea state wave conditions as well as wave overtopping have been measured. The changing foreshore showed a breaker bar formation as well as scour or accretion directly in front of the battered wall, depending on water level.

Full Text:

PDF

References


EurOtop (2016). Manual on wave overtopping of sea defences and related structures. An overtopping manual largely based on European research, but for worldwide application. www.overtopping-manual.com.

Smit, Stelling, Roelvink, Van Thiel de Vries, McCall, , Van Dongeren, Zwinkels, and Jacobs (2010). XBeach Non-hydrostatic model: validation, verification and model description. Report, Delft University of Technology, Delft, The Netherlands.




DOI: https://doi.org/10.9753/icce.v36.waves.65