Josep R. Medina, M. Esther Gómez-Martín


Recommended design KD are associated to implicit global safety factors to Initiation of Damage (IDa) and Initiation of Destruction (IDe). Zero-damage criterion is valid for double-layer armors of massive CAUs, but single-layer armors require a lower-than-zero damage criterion. A simple methodology is proposed to calculate design KD for Cubipod armors and to obtain reasonable explicit global safety factors to IDe and IDa when compared to benchmark CAUs. The stringent SF(IDe5%) is the lowest for double-layer trunk armors, higher for double-layer roundhead armors and the highest for single-layer trunk armors. Single-layer roundhead armors were not analyzed.


mound breakwater; concrete armor unit; Cubipod; stability coefficient; global safety factor

Full Text:



Bakker, P., Klabbers, M., Muttray, M. and A. Van den Berge. 2005. Hydraulic performance of Xbloc® armour units. 1st Int. Conf. on Coastal Zone Management and Engineering in the Middle East. Dubai, November 2005.

Burcharth, H.F. and T. Brejnegaard-Nielsen. 1986. The influence of waist thickness of dolosse on the hydraulic stability of dolosse armour. Proceedings of 20th Inernational Conference on Coastal Engineering, ASCE, 1783-1796.

Burcharth, H.F. and T. Lykke-Andersen. 2007. Scale effects related to small scale physical modelling of overtopping of rubble mound breakwaters. Proceedings of 5th International Conference Coastal Structures 2007, World Scientific, Vol. II, 1532-1541.

Burcharth, H.F., Andersen, T.L. and J.R. Medina. 2010. Stability of Cubipod armoured roundheads in short crested waves. Proceedings of 32nd International Conferencce on Coastal Engineering, ASCE, Paper No. 259/structures.39.

CIRIA/CUR, 1991. Manual of the use of rock in coastal and shoreline engineering. CIRIA Special Publication 83, London (UK), and CUR Report 154, Gouda (The Netherlands), 607 p.

CLI 2012. ACCROPODE™. The benchmark in single-layer armouring technology. http://www.concretelayer.com/ (Consulted 08/06/2012).

Dupray, S. and J. Roberts. 2009. Review of the use of concrete in the manufacture of concrete armour units. Proceedings of Coasts, Marine Structures and Breakwaters 2009, ICE, Thomas Telford Ltd., Vol 1, 260-271+298-299.

Gómez-Martín, M.E. and J.R. Medina. 2007. Cubipod concrete armor unit and heterogeneous packing. Proceedings of 5th Coastal Structures International Conference, World Scientific, 140-151.

Gómez-Martín, M.E. and J.R. Medina. 2008. Erosion of cube and Cubipod armor layers under wave attack. Proeedings of. 31st International Conference on Coastal Engineering, ASCE, 3461-3473.

Hanzawa, M., Kato, T., Kishira, Y., Ozawa, Y., Niidome, Y., Murakami, T., Ono, A., Hidaka, K.,Yoshida, H. and I. Tanaka. 2006. Fully reinforced 80t Dolos and sloping top caisson in Hososhima Port. Proceedings of 30th International Conference on Coastal Engineering, ASCE, 4805-4814.

Holtzhausen, A. H. and J.A. Zwamborn. 1991. Stability of Accropode® and comparison with dolosse. Coastal Engineering, 15(1-2): 59-86.http://dx.doi.org/10.1016/0378-3839(91)90042-F

Hudson, R.Y. 1959. Laboratory investigation of rubble-mound breakwaters. Journal of the Waterways and Harbors Division, ASCE, 85(WW3): 93–121.

Iribarren, R. 1965. Fórmula para el cálculo de los diques de escolleras naturales o artificiales. Revista de Obras Públicas, Colegio ICCP, Madrid. 113(3005):739-750+113(3006):829-849 (in Spanish).

Lomónaco, P., Vidal, C., Medina, J.R. and M.E. Gómez-Martín. 2009. Evolution of Damage on Roundheads Protected with Cube and Cubipod Armour Units. Proceedings of Coastal, Marine Structures and Breakwaters 2009. ICE, Thomas Telford Ltd., Vol. 1, 169-180+186-188.

Maci-eira-Alonso, E., Noya-Arquero, F. and V. Bajo-González. 2009. Breakwater construction at the new port in Punta Langosteira, A Coru-a, Spain. Execution process and technical innovation. Proceedings of Coasts, Marine Structures and Breakwaters 2009, ICE, Thomas Telford Ltd., Vol 1, 532-543.

Medina, J.R., M.E. Gómez-Martín and A. Corredor. 2010a. Influence of armor unit placement on armor porosity and hydraulic stability. Proceedings of 32nd International Conference on Coastal Engineering, ASCE, Paper No. 255/structures 41.

Medina, J.R., M.E., Gómez-Martín, A. Corredor and M. Santos. 2010b. Dise-o de diques en talud con el manto principal de cubípodos. Revista de Obras Públicas, Colegio ICCP, Madrid. 157 (3515): 37-52 (in Spanish).

Medina, J.R., M.E Gómez-Martín, A. Corredor, R. Torres, J.V. Mi-ana, E. Fernández, C.F. Menéndez, and M. Santos. 2011. Prototype drop tests of cube and Cubipod armor units. Journal of Waterway, Port, Coastal and Ocean Engineering, ASCE, 137(2): 54-63.http://dx.doi.org/10.1061/(ASCE)WW.1943-5460.0000064

PIANC. 1992. Analysis of Rubble Mound Breakwaters. Report of Working Group nº 12, Suppelement to Bulletin nº 78/79 (1992), Permanent International Association of Navigation Congresses, PIANC-AIPCN. ROM 0.0-01, 2001. General procedure and requirements in the design of harbor and maritime structures (Part 1). Project Development Miguel A. Losada. Puertos del Estado, Madrid, Spain.

SPM. 1975. Shore Protection Manual, U.S. Army Coastal Engineering Research Center, Fort Belvoir, Virginia.

SPM. 1984. Shore Protection Manual, Waterways Experiment Station, Corps of Engineers, Coastal Engineering Research Center, US Government Printing Office, Washington, DC.

Van der Meer, J.W. 1988. Stability of cubes, tetrapodes and Accropodes. Proceedings of Coasts, Marine Structures and Breakwaters 1988, ICE, Thomas Telford Ltd., 71-80.

Vincent, G., L. Tourmen and J. Gonzalo-Vara. 1989. Diques marítimos. Costes comparados de las corazas de diques construídas con bloques artificiales. Economía proporcionada por la utilización del bloque Accropode®. Revista de Obras Públicas, Colegio ICCP, Madrid. 136(3280): 457-466 and 136(3283): 657-667 (in Spanish).

DOI: https://doi.org/10.9753/icce.v33.structures.29