SUBGRID MODELLING IN DEPTH INTEGRATED FLOWS
PDF

Keywords

depth integrated flow
subgrid modeling

How to Cite

Madsen, P., Rugbjerg, M., & Warren, I. (1988). SUBGRID MODELLING IN DEPTH INTEGRATED FLOWS. Coastal Engineering Proceedings, 1(21), 35. https://doi.org/10.9753/icce.v21.35

Abstract

Hydrodynamic simulations in coastal engineering studies are still most commonly carried out using two-dimensional vertically integrated mathematical models. As yet, threedimensional models are too expensive to be put into general use. However, the tendency with 2-D models is to use finer and finer resolution so that it becomes necessary to include approximations to some 3-D phenomena. It has been shown by many authors that simulations of large scale eddies can be quite realistic in 2-D models (c.f. Abbott et al. 1985). Basically there exists two different mechanisms of circulation generation. The first one is based on a balance between horizontally and grid-resolved momentum transfers and the bed resistance - i.e. a balance between the convective momentum terms and the bottom shear stress. The second one is due to momentum transfers that are not resolved at the grid scale but appears instead as horizontally distributed shear stresses. In many practical situations the circulations will be governed by the first mechanism. This is the case if the diameter of the circulation and the grid size is much larger than the water depth. In this situation the eddies are friction dominated so that the effect of sub-grid eddy viscosity is limited. In this case 2-D models are known to produce very realistic results and several comparisons with measurements have been reported in the literature.
https://doi.org/10.9753/icce.v21.35
PDF
Authors retain copyright and grant the Proceedings right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this Proceedings.